Appliance Configuration
Check Point 1400 Appliances Centrally Managed Administration Guide R77.20.85 | 51
• Refresh - Refresh the information in the list.
• Start/Stop Traffic Monitor - Gather upload and download packet rates for active devices. The
information is shown in the added Traffic column in the table.
This operation may affect performance.
To stop, click Stop Traffic Monitoring.
The display shows the devices connected to the gateway through a Hotspot. You can revoke the
Hotspot access for one or more devices. This disconnects the device from the gateway and
requires the device to log in again through the Hotspot.
To revoke the Hotspot access:
Click the record for the relevant device.
Click Revoke Hotspot Access.
The access for that device is revoked. You must log in again through the Hotspot to reconnect
the device to the gateway.
Note - If there is no IPv6 activity in a dual stack host, the Active devices do not show the IPv6
address.
Note - This page is available from the Home and Logs & Monitoring tabs.
Viewing Monitoring Data
The Monitoring page shows network, security, and troubleshooting information. When you enter
this page, the latest data shows. You can click Refresh to update information. To see a sample
monitoring report, click Demo. To close the sample reports, click Back.
The number of current connections in the system is shown for VPN Tunnels, Active Devices, and
Connections. You can click the links to open the corresponding WebUI pages.
The Monitoring page is divided into these sections:
• Network
• Security
• Troubleshooting
To expand or collapse the sections, click the arrow icon in the section's title bar.
By default, network statistics are shown for the last hour. You can also see statistics for the last
day. Select the applicable option Last hour or Last day from the Network section's title bar.
The data is automatically refreshed for the time period:
Last hour - At one minute intervals. For example, if you generate a report at 10:15:45 AM, the
report represents data from 9:15 to 10:15 AM.
Last day - At hourly intervals. For example, if you generate a report at 10:15 AM, the report
represents data from the last 24 hours ending at 10:00 AM of the current day.
• Bandwidth Usage - The doughnut chart shows the top 10 applications or users that consumed
the most bandwidth in the selected time frame (last hour or last day). Click the Applications or
Users links to toggle between the statistics. To show user information the User Awareness
blade must be activated.
• Top Bandwidth Consuming - Shows statistics for the top bandwidth consuming application,
category, site, and user in percentages and the amount of traffic (MB or GB).
To Next Page
Loading...
