Check Point L-71 - Using the Set Property Command

First Time Deployment Options
Check Point 1400 Appliances Centrally Managed Administration Guide R77.20.85 | 44
If you cannot repair the configuration file:
1.
Remove the USB drive.
2.
Run the CLI command: restore default-settings.
3.
Connect to the Web UI and use the First Time Configuration Wizard to configure the appliance.
If you understand the error and know how to repair the configuration file:
1.
Remove the USB drive.
2.
Run the CLI command: restore default-settings.
3.
Insert the USB drive and run the repaired configuration script again.
Sample Configuration Log with Error
This is a sample configuration log file for a configuration script that fails.
set hostname Demo1
set hostname: Setting hostname to 'Demo1'
OK
set interface WAN internet primary ipv4-address 66.66.66.11
Error: missing argument 'subnet-mask' for a new connection
Autoconfiguration CLI script failed, clish return code = 1
Using the set property Command
The set property CLI command controls how the Check Point Appliance runs configuration
scripts from a USB drive. These commands do not change how the First Time Configuration
Wizard in the Web UI configures the appliance.
• set propert USB_auto_configuration off - The appliance does not run configuration
scripts from a USB drive.
• set propert USB_auto_configuration once - The appliance only runs the next
configuration script from a USB drive.
• set propert USB_auto_configuration any - The appliance always runs configuration
scripts from a USB drive.