Check Point L-71 - Advanced Configuration; Dynamic Routing

Check Point 1400 Appliances Centrally Managed Administration Guide R77.20.85 | 115
C H A P TE R 9
Advanced Configuration
In This Section:
Dynamic Routing ............................................................................................... 115
Upgrade Using a USB Drive ............................................................................... 116
Upgrade Using an SD Card ................................................................................ 117
Boot Loader ..................................................................................................... 118
Upgrade Using Boot Loader ............................................................................... 119
Restoring Factory Defaults .............................................................................. 120
Dynamic Routing
Dynamic Routing is supported with Gaia networking stacks. RIP, OSPF, BGP, and PIM are
supported.
Note - Configuration is only supported through the CLI.
This is a sample OSPF interface configuration:
set ospf
area <backbone | ospf_area> range ip_prefix <on | off>
area <backbone | ospf_area> range ip_prefix restrict <on | off>
stub-network ip_prefix <on | off>
stub-network ip_prefix stub-network-cost <1-677722>
set ospf interface if_name
area <backbone | ospf_area> <on | off>
hello-interval <1-65535>
hello-interval default
dead-interval <1-65535>
dead-interval default
retransmit-interval <1-65535>
retransmit-interval default
cost <1-65535>
priority <0-255>
passive <on | off>
virtual-address <on | off>
authtype none
simple password
md5 key authorization key id secret md5 secret
md5 key authorization key id
See the Gaia Advanced Routing Administration Guide for more information.
Note - The save config and route map commands are not supported.