Check Point L-71 - Page 121

Advanced Configuration
Check Point 1400 Appliances Centrally Managed Administration Guide R77.20.85 | 121
8. Install DSL Firmware/Upload preset configuration file
Please enter your selection :
3.
Enter 4 to select Restore to Factory Defaults (local).
4.
When you are prompted: "Are you sure? (y/n)" select y to continue and restore the appliance to
its factory defaults settings.
While factory defaults are restored, all LAN Link and Activity LEDs blink orange and green
alternately to indicate progress. This takes up to a few minutes. When completed, the
appliance boots automatically.
To disable the reset to default:
Use this CLI command:
>set additional-hw-settings reset-timeout 0
To enable the reset to default:
Use this CLI command:
>set additional-hw-settings reset-timeout 12