Check Point L-71 - Page 37

SmartProvisioning
Check Point 1400 Appliances Centrally Managed Administration Guide R77.20.85 | 37
This table maps the profile settings selections to the Gateway window options:
Profile
managed
Profile Override Gateway Window Display and options
Locally Not relevant Settings are defined to be managed locally on the device.
To change this, refer to the attached Provisioning Profile
profile_name .
(controls are unavailable)
Centrally Override denied Overriding profile settings is denied.
To change this, refer to the attached Provisioning Profile
profile_name
(controls are Read-Only, configured by profile)
Centrally Override allowed Select override method:
• Manage settings locally on the device: Local management.
Override provisioning configurations with local settings.
• Use profile settings: Enforce profile settings on this gateway.
• Use the following settings: Manage these settings on this gateway
individually with the values given here.
Centrally Override
mandatory
Overriding profile settings is mandatory: configure settings
here.
To change this, refer to Provisioning Profile
profile_name
(Each gateway is configured separately)
• Manage settings locally on the device: Manage these settings on
this gateway locally.
• Use the following settings: Manage these settings on this gateway
individually with the values given here.
For example, if you set Hosts configuration to Central and Allowed: The Hosts tab on the gateway
enables you to manage the Host List of a gateway if you:
• Define the Host List locally on the device (even if it has an assigned Provisioning Profile)
• Provision gateways with the Host List of the Provisioning Profile
• Define a New Host List (in the Gateway window) that overrides the Provisioning Profile on this
gateway
Warning - If you select Use the following settings and do not enter values for a
specified topic, the current settings on the device are deleted.