First Time Deployment Options
Check Point 1400 Appliances Centrally Managed Administration Guide R77.20.85 | 39
To connect to the Zero Touch server from the First Time Configuration Wizard:
1.
In the Welcome page of the First Time Configuration Wizard, click Fetch Settings from the
cloud.
In the window that opens, click Yes to confirm that you want to proceed.
The Internet connection page of First Time Configuration Wizard opens. Configure your
Internet connection and click Connect.
The settings are automatically downloaded and installed.
A new window opens and shows the installation status. It may take several minutes until the
installation is complete.
Note - If a collision is detected between an internal network (LAN) and an IP returned via DHCP
(WAN), the conflicting LAN address is changed automatically. If a colliding LAN IP address is
changed, a message appears in the system logs.
When you reconnect to the WebUI or click Refresh, the browser opens to show the status of the
installation process.
After the gateway downloads and successfully applies the settings, it does not connect to the Zero
Touch server again.
For more information on how to use Zero Touch, see sk116375
http://supportcontent.checkpoint.com/solutions?id=sk116375 and the
Check Point SMB Zero
Touch User Guide
http://downloads.checkpoint.com/dc/download.htm?ID=53585.
To Next Page
Loading...
