Appliance Configuration
Check Point 1400 Appliances Centrally Managed Administration Guide R77.20.85 | 63
DHCPv4 Server section
Select one of the options:
• Enabled - Enter the IP address range and if necessary the IP address exclude range. The
appliance's own IP address is automatically excluded from this range. You can also exclude or
reserve specific IP addresses by defining network objects in the Users & Objects > Network
Objects page. Reserving specific IP addresses requires the MAC address of the device.
• Relay - Enter the DHCP server IP address.
• Disabled
IPv6 Auto Assignment section
Select one of the options:
• SLAAC (Stateless Address Autoconfiguration)
• DHCPv6 Server - Enter the IP address range and the IP addresses exclude range
• DHCPv6 Server Relay - Enter the DHCPv6 server IP address and the Secondary DHCPv6
server IP address
These options create automatic rules that are shown in the Access Policy > Firewall Policy page.
• Allow access from this network to local networks (Wireless network is trusted)
• Log traffic from this network to local networks
Click the checkbox to exclude from DNS proxy.
Advanced IPv6 Settings
Configure the Router Advisement fields.
Note - In IPv4-only mode, this tab is called DHCP4 Settings.
The values for the DHCP options configured on this tab will be distributed by the DHCP server to
the DHCP clients.
DHCP Server Settings (For DHCPv6/SLAAC)
Select one of these options:
• Auto - Use the DNS configuration of the device.
• Use the following IP addresses - Enter the first, second and third DNS servers.
DNS Server Settings (For DHCPv4)
These settings are effective only if a DHCPv4 server is enabled.
Select one of these options:
• Auto - This uses the DNS configuration of the appliance as configured in the Device > DNS and
Device > Internet pages.
• Use the following IP addresses - Enter the IP addresses for the First DNS server, Second
DNS server, and Third DNS server.
To Next Page
Loading...
