Check Point L-71 - Page 78

Appliance Configuration
Check Point 1400 Appliances Centrally Managed Administration Guide R77.20.85 | 78
To enable 802.1x authentication on a tag based VLAN interface:
1.
Go to Device > Local Network.
2.
Select the LAN and click New > VLAN.
The New VLAN window opens in the Configuration tab.
3.
For Assigned to: select the LAN ID.
4.
In the Advanced tab, select Activate 802.1x authentication.
5.
Enter a time for Re-authentication frequency (in seconds).
6.
Click Apply.
To disable 802.1x authentication on an interface:
1.
Go to Device > Local Network.
Select the LAN interface and click Edit.
2.
The Edit window opens in the Configuration tab.
3.
Click the Advanced tab.
4.
Clear Activate 802.1x authentication.
5.
Click Apply.
To configure logging for MAC filtering and 802.1x authentication:
1.
Go to Device > Advanced Settings.
2.
Set the value of the MAC Filtering settings - Log blocked MAC addresses attribute to
• Enabled - To enable logging
• Disabled - To disable logging.
Note - This attribute is available only in Locally Managed mode. In Centrally Managed mode,
configure logging with CLI.
3.
Optional -
• To reduce the number of logs, specify the value of the MAC Filtering settings - Log
suspension attribute in seconds.
• To show all logs, set the value to “0”.
Note - Traffic dropped in the WiFi driver is not logged.