Check Point L-71 - Page 82

Appliance Configuration
Check Point 1400 Appliances Centrally Managed Administration Guide R77.20.85 | 82
To restore a backed up configuration:
1.
Click Restore. The Restore Settings page appears.
2.
Browse to the location of the backed up file.
3.
Click Upload File.
Important Notes
• To replace an existing appliance with another one (for example, upon hardware failure) you
can restore the settings saved on your previous appliance and reactivate your license (through
Device > License).
• To
duplicate an existing appliance you can restore the settings of the original appliance on the
new one.
• Restoring settings of a different version is supported, but not automatically between every two
versions. If the restore action is not supported between two versions, the gateway does not
allow you to restore the settings.
IPv6 Mode
To enable IPv6 networking and enforce IPv6 security:
1.
Click IPv6 Enforcement Settings.
The IPv6 Enforcement Settings window opens.
2.
To enforce IPv6 security policy, click the checkbox.
3.
To enable IPv6 networking, click the checkbox.
4.
Click Apply.
Note - This causes the appliance to reboot.
Using the Software Upgrade Wizard
Follow the instructions in each page of the Software Upgrade Wizard.
During the wizard click Cancel to quit the wizard.
Welcome
Click the Check Point Download Center link to download an upgrade package as directed. If you
already downloaded the file, you can skip this step.
Upload Software
Click Browse to select the upgrade package file.
Click Upload. This may take a few minutes. When the upload is complete, the wizard automatically
validates the image. A progress indicator at the bottom of the page tells you the percentage
completed. When there is successful image validation, an "Upload Finished" status shows.
Upgrade Settings
The system always performs an upgrade on a separate flash partition and your current-running
partition is not affected. You can always switch back to the current image if there is an immediate
failure in the upgrade process. If the appliance does not come up properly from the boot,
disconnect the power cable and reconnect it. The appliance automatically reverts to the previous
image.