Check Point L-71 - Page 89

Appliance Configuration
Check Point 1400 Appliances Centrally Managed Administration Guide R77.20.85 | 89
To allow administrator access from any IP address:
1.
Select the Any IP address option. This option is less secure and not recommended. We
recommend you allow access from the Internet to specific IP addresses only.
2.
Change the WEB Port (HTTPS) and/or SSH port if necessary.
3.
Click Apply. An administrator can access the Check Point Appliance using any IP address
through the allowed interface sources.
To allow administrator access from specified IP addresses:
1.
Select the Specified IP addresses only option.
2.
Click New.
The IP Address Configuration page shows.
3.
Select Type:
• IPV4 address
• IPv4 network
• IPv6 address
• IPv6 network
4.
Enter the IP address or click Get IP from My Computer.
5.
Click Apply.
The IP address is added to the table.
6.
Change the WEB Port (HTTPS) and/or SSH port if necessary.
7.
Click Apply. An administrator can access the Check Point Appliance using the configured IP
addresses through the allowed interface sources.
To allow administrator access from both specified and any IP addresses:
Select this option when it is necessary to allow administrator access from the Internet (you must
define the specified IP addresses). Access from other sources is allowed from any IP address.
1.
Select the Internet source checkbox.
2.
Select the Specified IP addresses from the internet and any IP address from other sources
option.
3.
Click New.
The IP Address Configuration page shows.
4.
Select Type:
• IPV4 address
• IPv4 network
• IPv6 address
• IPv6 network
5.
Enter the IP address or click Get IP from My Computer.
6.
Click Apply.
The IP address is added to the table.
7.
Change the WEB Port (HTTPS) and/or SSH port if necessary.
8.
Click Apply. An administrator can access the Check Point Appliance using the configured IP
addresses through the allowed interface sources.