Check Point L-71 - Page 98

Appliance Configuration
Check Point 1400 Appliances Centrally Managed Administration Guide R77.20.85 | 98
The correct Administrator Role must be configured to perform the operations listed below. If not,
a Permission Error message shows.
To create a local administrator:
1.
Click New.
The Add Administrator page opens.
2.
Configure the parameters (name, password, and password confirmation). The hyphen (-)
character is allowed in the administrator name. You cannot use these characters when you
enter a password or shared secret: { } [ ] ` ~ | ‘ " # + \
3.
Select the Administrator Role.
4.
Click Apply.
The name and Administrator Role is added to the table. When logged in to the WebUI, the
administrator name and role is shown at the top of the page.
To edit the details of locally defined administrators:
1.
Select the administrator from the table and click Edit.
2.
Make the relevant changes.
3.
Click Apply.
To delete a locally defined administrator:
1.
Select an administrator from the list.
2.
Click Delete.
3.
Click Yes in the confirmation message.
Note - You cannot delete an administrator who is currently logged in.
To allow access for administrators defined in a remote RADIUS server:
1.
Make sure administrators are defined in the remote RADIUS server.
2.
Make sure a RADIUS server is defined on the appliance. If there is no server, click the RADIUS
configuration link at the top of this page. You must configure the IP address and shared secret
used by the RADIUS server.
3.
When you have a configured RADIUS server, click edit permissions.
The RADIUS Authentication window opens.
4.
Click the Enable RADIUS authentication for administrators checkbox.
Use roles defined on RADIUS server is selected by default.
5.
Configure the role for each user on the RADIUS server. See additional details below.
Note - A user without role definition will get a login error.
6.
If you select Use default role for RADIUS users, select the Administrators Role:
• Super Admin
• Read only
• Networking Admin
7.
To define groups, click Use specific RADIUS groups only and enter the RADIUS groups
separated by a comma.
8.
Click Apply.