Using the First Time Configuration Wizard
Quantum Spark 1530 / 1550 Appliance R80.20.XX Getting Started Guide|26
When you configure a wireless network, you must define a network name (SSID). The SSID (service set
identifier) is a unique string that identifies a WLAN network to clients that try to open a wireless connection
with it.
We recommend that you protect the wireless network with a password. Otherwise, a wireless client can
connect to the network without authentication.
To configure the wireless network now:
1. Select Configure wireless network now.
2. Enter a name in the Network name (SSID) field. This is the name shown to clients that look for
access points in the transmission area.
3. Select Protected network (recommended) if the wireless network is protected by password.
4. Enter a Password.
5. The Hide password option is selected by default.
6. Allow access from this network to the local network is selected by default. This means the
wireless network is considered trusted and access is allowed from it to the local network.
7.
Radio Band
n 2.4GHz: 2414-2462 MHz
n 5GHz: 5180-5240, 5260-5320, 5500-5720, 5745- 5825MHz
Administrator Access
In the Administrator Access page, configure if administrators can use the appliance from a specified IP
address or any IP address.
To Next Page
Loading...
