Check Point Smart-1 series Replacing Instructions

Classification [Protected] P/N:705869 | 1
© 2014 Check Point Software Technologies Ltd. All rights reserved.
For a list of our trademarks, please refer to: http://www.checkpoint.com/copyright.html.
For a list of our Third Party Copyright notices, please refer to: http://www.checkpoint.com/3rd_party_copyright.html
Replacing Smart-1 AC Power
Supply Units
705869
Protected
2014
This document is for Smart-1 225, Smart-1 3050, and Smart-1 3150 models.
Smart-1 has a redundant power supply unit. If necessary, you can replace a power
supply unit.
Important - Make sure you are electromagnetically grounded before you install,
uninstall, or replace a PSU. ESD (electrostatic discharge) can damage the
appliance.
Note: The illustrations in this guide show the Smart-1 3050. The procedures are the
same for all models, but the component locations can be different.

Check Point Smart-1 series Specifications

General

Input Voltage	100-240 VAC
Frequency	50/60 Hz
Redundant Power Supply	Optional
Operating Temperature	0°C to 40°C
Storage Temperature	-20°C to 70°C