F10 Installation Manual Rev. *60 25 of 71
CHAPTER
4
WIRING
Overview
This chapter instructs on the wiring of the entire floor system. There is a progression from the
antenna to the electronics enclosure and common peripherals. Chapter 4: Wiring concludes with
the DC power supply connections and system sync (optional) wiring schemes for multi-antenna
configurations (i.e., when two or more electronics enclosures are synced – to operate as a unit).
CAUTION: This system uses TR4215
†
DMS version 1.8.31 or later must be used to configure the system after wiring is complete (refer
to
electronics with firmware version 4.00 or higher. It is critical to note
that only TR4215 electronics can be used in conjunction with this system.
Chapter 5: F10 System Configuration via DMS).
The outline below is a sequence of the F10, 1 and 2 meter system wiring procedures:
1. Antenna Wiring
a. Components and Placement
b. Wiring the F10, 1 and 2 meter Antennas to the Impedance Matching Board
2. Electronics Chassis
a. Coax cable Wiring to the Coax Adapter Board
b. Remote Voice Alarm Group Wiring
c. Alarm Post Wiring
d. DC Power Supply Wiring
e. Sync Cable and Power Wiring
To Next Page
Loading...