2-10 Keys, Doors, and Windows
Activating the Remote Start
To heat or cool the passenger
compartment using remote start:
1. Aim the RKE transmitter at the
vehicle.
2. Press
Q on the RKE transmitter;
the doors will lock.
3. Within five seconds, press and
hold
B until the turn signal
lamps flash, or for approximately
four seconds. Pressing
B again
during a remote start will turn the
feature off.
Remote start will automatically shut
off after 10 minutes unless a time
extension is done.
While the remote start is active, the
parking lamps will turn on and
remain on.
After entering the vehicle during a
remote start, press the POWER
O
button on the center stack with the
brake pedal applied to operate as
normal.
The remote start can be initiated
two separate times between driving.
For each remote start, the
passenger compartment will be
heated or cooled for 10 minutes.
Extending the Time
To extend the time of the first
remote start, repeat the steps for
activating remote start. Remote start
can only be extended one time
between driving.
Canceling Remote Start
To cancel a remote start, do any of
the following:
.
Aim the RKE transmitter at the
vehicle and press and hold
B
until the parking lamps turn off.
.
Turn on the hazard warning
flashers.
.
Press the POWER O button on
the center stack, with the brake
pedal applied, then press the
POWER
O button again to turn
the vehicle off.
Conditions in Which Remote
Start May Not Work
Conditions in which a remote start
may not occur include:
.
An open hood.
.
Vehicle propulsion system fault
conditions, including an
emission control system
malfunction.
.
High voltage battery fault
conditions.
A second remote start or extension
will not occur if the fuel level is low.
To Next Page
Loading...
