14 chorewarrior.com Customer Service: 651-370-7508
OPERATING YOUR CHORE WARRIOR
WATCH FOR HAZARDS: Using the Chore Warrior on or near steep inclines can cause your Chore Warrior to be uncontrollable and cause
injury to yourself and others and/or damage to property. On steep inclines/declines, the Chore Warrior could reach an unsafe speed.
Operating the Chore Warrior on steep inclines/declines can cause the Chore Warrior to tilt, tip, or possibly roll over. Another danger is loss of
drive wheel traction. All of the above can cause the Chore Warrior to run out of control, resulting in possible harm and injury to yourself and/
or others. It can also result in damage to your Chore Warrior and/or other property. Keep your feet rmly on the ground and two hands on the
Chore Warrior handles to maintain control at all times.
BEFORE OPERATION OF YOUR CHORE WARRIOR: Your new Chore Warrior is similar to any other power driven tool. Although very easy
to operate, it will take some familiarity with the controls and balance to master it fully. Before operating the Chore Warrior, it is a good idea
to get familiar with controlling your Chore Warrior. Your Chore Warrior operates in much of the same way as a standard manually operated
wheelbarrow – the only major difference is your Chore Warrior has an optional forward/reverse power assist. According to your physical
capability, the Chore Warrior can easily be moved directionally as you desire.
MANUAL OPERATION OF YOUR CHORE WARRIOR: With power switch in the OFF (0) position take the
Chore Warrior to a large open outside area. Grasp the handles with both hands, lift the Chore Warrior until the
support legs are off the ground and the weight of the load is transferred to the drive wheels. In this position
manually push forward, backwards, and practice turning the Chore Warrior. To dump the Chore Warrior, lift both
handles in an upward forward motion, pivoting on the drive wheels and onto the dump support brace until the
tub is in a vertical position.
POWER ASSIST OPERATION OF YOUR CHORE WARRIOR: Use the same care when operating the Chore Warrior in
both manual and/or power assist modes.
Turn ON the power switch located on the electronics box. The battery indicator lights should illuminate on the top of
the control module mounted on the right handle. (If they do not illuminate see the troubleshooting section.) Your Chore
Warrior is now ready for operation.
CONTROLS
FORWARD/REVERSE BUTTON: The forward and reverse button is located on the left (thumb)
side of the right handle control module. Pushing this button will change the direction of
forward or reverse.
REVERSE: In the reverse position the Chore Warrior is designed to achieve a walk speed. This
low walking speed is designed for safety reasons. Use CAUTION when the Chore Warrior is in
reverse. Keep both hands on the handles and solid footing.
FORWARD: The forward position has a built-in additional power boost when throttle is
pushed down fully. At full throttle the Chore Warrior will move forward at a very fast walk
speed. Take special care when using full throttle. Power boost is designed for use when
climbing hills with the tray loaded.
CAUTION
Forward/
Reverse
button
Throttle
To Next Page
Loading...