CHORE WARRIOR 44322 - Drive System Assembly

chorewarrior.com Customer Service: 651-370-7508 5
DRIVE SYSTEM ASSEMBLY
IMPORTANT!
1. Attach left and right axles (B) to motor using axle ange gaskets (Q) and axle ange screws (R).
Tighten hardware.
NOTE: red dots (right) and blue dots (left) should line up as shown. You may have to wiggle the
axle a bit to "marry" the grooves and line up the screw holes correctly.
2. Attach left (L) and right (M) axle frame mounts to corresponding axles as shown using M10 x 20mm hex bolts (W) and washers (Y).
Tighten hardware.
NOTE: single tab side of each axle frame mount should face towards motor.
Q
R
B
M
TIGHTEN HARDWARE
After drive system assembly,
tighten all hardware.
W
W
Y