High Power DC Electronic Load 63200 Series Operation & Programming Manual
For example: Combine the following two command statements:
RES:RISE 100 <nl> and
RES:L1 400 <nl>
which can be formed into one command line as follows:
RES:RISE 100;L1 400 <nl>
5. To return to the root-level form you can
1. Enter a new-line character. This is symbolized as “<nl>” and can be linefeed “LF”
or/and end-of-line “EOL”. Or else,
2. Enter a semicolon followed by a colon “;:”.
Please refer to the following figure.
1. (root):VOLT:L1: 30<nl>
Starting a New Line to return to the Root.
2. (root):SPEC:VOLT:H 30;
:L 5;:
(root)RES:L1 400;
:RISE 1000;:
6-4
To Next Page
Loading...
