Chroma 6404 - Sound (ON;OFF); System Test

Local Operation
3-3
Action
Display
1. Enter configuration setup as stated in sec. 3.2, if
required.
SEt UP 1
2. Press 3 , ENTER .
OVP SEt 300.0
3. Press 1 , 2 , 0 , ENTER
OVP SEt 120.0
4. Press OUT/QUIT .
SEt Up 3
5. Select other setups by numeric keys or,
press OUT/QUIT again to exit from setup.
Default limit is 300V.
3.2.4 Sound (ON/OFF)
The 6404/6408 offers the user selection of beep sounds while programming using keypad
or turning . Default setting is “ON”, to disable it, the user can do as below:
Action
Display
1. Enter configuration setup as stated in sec. 3.2, if
required.
SEt UP 1
2. Press 4 , ENTER
bEEP on
3. Turn to change the option to be “OFF” and
press ENTER .
bEEP oFF
4. Press OUT/QUIT .
SEt Up 4
5. Select other setups by numeric keys or,
press OUT/QUIT again to exit from setup.
3.2.5 System test
The user is allowed to check if the output power is within spec to the setting value. To
enable the test, follow the procedures described below:
Action
Display
1. Enter configuration setup as stated in sec. 3.2, if
required.
SEt Up 1
2. Press 5 , and ENTER .
SYS tESt no
3. Turn to change the option to be “YES” and
press ENTER
.
SYS tESt YES
4. Press OUT/QUIT .
SEt Up 5
5. Select other setups by numeric keys or,
press OUT/QUIT again to exit from setup.