Chrysler PACIFICA 2018 - Keysense Cluster Messages - if Equipped

Without pressing the brake pedal, push the ENGINE
START/STOP button and place the ignition in the ON/
RUN position (do not start the vehicle.)
1. Push the OK button to enter the instrument cluster
display menu screen.
2. Push and release the down arrow button to access the
”Oil Life” menu screen.
3. Push the left arrow button or right arrow button to
access the “Vehicle Info” submenu.
4. Hold the OK button to reset the “Oil Life” to 100%.
5. Push the up arrow button to exit the instrument cluster
display menu screen.
NOTE: If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary, repeat this procedure.
KeySense Cluster Messages — If Equipped
When the KeySense key is in use there will be:
• Continuous, dedicated
telltale
• Unique Display Splash Screen
With KeySense in use there will be multiple associated
messages shown in the following table:
Setting Instrument Cluster Display Message
None – With vehicle ignition
ON
“KeySense in use. Max vehicle speed set to xx MPH/or km/h”
Max Vehicle Speed
• “Max speed reached. KeySense in use” supported by a chime
• “Approaching max speed xx MPH/km” supported by a chime
Start Up Fuel Alert message “Range to empty xxx miles or km”
Early Low Fuel Alert Message “Fuel Low”
192 GETTING TO KNOW YOUR INSTRUMENT PANEL