EasyManua.ls Logo

Chrysler PACIFICA 2018 - General Information; Vehicle Security Alarm - if Equipped; Rearming of the System; To Arm the System

Chrysler PACIFICA 2018
716 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
General Information
The following regulatory statement applies to all radio
frequency (RF) devices equipped in this vehicle:
This device complies with Part 15 of the FCC Rules and
with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, in-
cluding interference that may cause undesired opera-
tion.
NOTE: Changes or modifications not expressly approved
by the party responsible for compliance could void the
user’s authority to operate the equipment.
VEHICLE SECURITY ALARM IF EQUIPPED
The vehicle security alarm monitors the vehicle doors for
unauthorized entry and the ignition switch for unauthor-
ized operation. When the alarm is activated, the interior
switches for door locks, power sliding doors and power
liftgate are disabled. The vehicle security alarm provides
both audible and visible signals. If something triggers the
alarm, the vehicle security alarm will provide the following
audible and visible signals: the horn will pulse, the park
lamps and/or turn signals will flash, and the vehicle
security light in the instrument cluster will flash.
Rearming Of The System
If something triggers the alarm, and no action is taken to
disarm it, the vehicle security alarm will turn the horn off
after 29 seconds, 5 seconds between cycles, up to 8 cycles if
the trigger remains active and then the vehicle security
alarm will rearm itself.
To Arm The System
Follow these steps to arm the vehicle security alarm:
1. Make sure the vehicles ignition is cycled to the “OFF”
position (refer to Starting The Engine in Starting And
Operating for further information).
For vehicles equipped with Keyless Enter-N-Go
Passive Entry, make sure the vehicle ignition system is
OFF.
2. Perform one of the following methods to lock the
vehicle:
Push lock on the interior power door lock switch with
the driver and/or passenger door open.
Push the lock button on the exterior Passive Entry
Door Handle with a valid key fob available in the same
3
GETTING TO KNOW YOUR VEHICLE 33

Table of Contents

Other manuals for Chrysler PACIFICA 2018

Related product manuals