Chuango H4 User Manual

19 20
System Settings
Tap [ ] and enter the interface for system settings to perform operations.
Account Management
Enter the interface for account management and tap [+]. You may add subuser
accounts; enter usernames and tap [Conrm]. The account labelled with [ ] is the
master account. Tap the [ ] button to change the password for this account. The
master may add a maximum of 5 subuser accounts in this interface.
Note: The default subuser password is 123456. To change the password, login to the App by
entering the subuser account name and the default password, and then
tap
the [ ] button
in the interface for user management. To remove a subuser account,
tap
App [ ]. After
cancellation of the account, subuser accounts added by that user will also be cancelled.
Save Alarm Phone Number
With a SIM card inserted into the panel, you may switch to the GPRS network to
remote control the system during disconnection of WiFi network. After saving the
alarm phone number in the App interface below, the user will receive an alarm call in
case of emergency.
Internal Siren Setup
1. The arm/disarm tone of the internal siren can be turned off by slipping the switch on
the App.
2. Tap [Internal siren volume] to choose the alarm volume level: mute, low, medium and
high. The default setting is high.
3. Tap [Internal Siren Ringing Time] to set internal siren alarming duration from 1 to 9
minutes. Default setting is 5 min.
Entry & Exit Delay
If you do not want to carry the remote control, you may set a system delay time. Delay
refers to entry & exit delay, including Arm delay before leaving home and Alarm delay
after entering the home. If the delay time is set to 30 seconds, set the system to Arm
before leaving home. The panel will make a “Di” sound once every 2 seconds to remind
the user to leave. The speed increases during the last 15 seconds. From setting the system
to Arm to the start of operation, 30 seconds will elapse. A system that has been set to Arm
status will activate the alarm 30 seconds after a user triggers an accessory ( which sets to
entrance delay zone ) upon entering the home, thereby giving the user enough time to set
the system to Disarm.

Chuango H4 Specifications

General

Wi-Fi	Yes
Alarm decibels	105 dB
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Operating frequency	433 MHz
Operating temperature (T-T)	0 - 55 °C
Operating relative humidity (H-H)	0 - 80 %
Number of supported remote controls	10
Number of simultaneously connected devices (max)	70
Product color	White
Housing material	Acrylonitrile butadiene styrene (ABS)
Motion sensor technology	Passive infrared (PIR) sensor
Number of remote controls	2 pc(s)
Number of door/window sensors	1 pc(s)
Alarm current	300 mA
Static current	100 mA
Battery voltage	3.7 V
Battery capacity	800 mAh
Battery technology	Lithium