Need help?Do you have a question about the CIAT AQUALIS 2 35 and is the answer not in the manual?
Steps for protecting the system from freezing temperatures using glycol and specific settings.
Details on voltage, frequency, phase requirements, and wiring standards for power supply.
Essential checks to perform on the unit and system before initiating operation.
Step-by-step guide for powering on the unit and setting the initial operating mode.
Process for removing air from the water circuit to ensure proper system functioning.
General maintenance tasks for unit components like fans, compressor, and circulator.
Advice on maintenance contracts and mandatory yearly checks for system upkeep.
Explanation of the control terminal screen, its indicators, and dial operation.
Procedure for navigating and changing unit settings identified by 'P' numbers.
How to select and configure cooling, heating, and frost protection modes based on system type.
Setting P6 to define auxiliary units (electric, boiler) and bypass possibilities.
Methods for integrating a boiler as a backup heat source, controlled by its own system or Microconnect.
Turning off or bypassing the unit via remote signal using terminal block J2.
Detailed list of fault codes, their descriptions, types, and possible causes.
To Next Page
General