To Next PageTo Next Page
Need help?Do you have a question about the CIAT AUREA Series and is the answer not in the manual?
General| Category | Heat Pump |
|---|---|
| Series | AUREA |
| Refrigerant | R32 |
| Operating Temperature Range (Heating) | -15°C to 35°C |
| Power Supply | 220-240V, 50Hz |
General introduction to AUREA reversible heat pumps for residential and commercial use.
Essential precautions for installation, commissioning, and adjustment operations.
Guidelines for moving, placing, and installing the heat pump unit indoors.
Study of dimensioning, filtration, water temperature limits, and pipework insulation requirements.
Compliance with standards, wiring regulations, and power supply characteristics for safe installation.
Procedure for adjusting the manual valve on the external circuit using reference curves.
Accessing and modifying user and factory parameters, protected by passwords.
Parameters related to compressor minimum operating time, stop time, and anti-short cycle.
Parameters for frost protection settings, including setpoints and differentials for internal/external exchangers.
Diagram showing the location of sensors and safety devices within the unit.
Procedures for initial checks, powering on, and starting the heat pump unit.
Diagnosing and resolving common issues encountered during unit startup.
General explanation of fault detection, signalling, and reset procedures.
Detailed descriptions of various faults including pressure, temperature, flow, and sensor issues.
Overview of safety devices managed by the controller, including pressure switches and sensors.
Performance data for AUREA models, including compressor, heat exchangers, and power.
Electrical supply requirements, current ratings, and cable specifications.
Measurement of sound pressure levels for different unit models.
Schematic showing the installation principle for units using well or ground water sources.
Schematic showing the installation principle for units using horizontal or vertical geothermal sensors.
Table for recording operational data, measurements, and checks during service.
How to control unit operation via external signals, remote control, and mode selection.
Connecting and controlling external/internal water pumps and electric control valves.
