CIAT GeoCIAT - Page 26

EN - 24
Replacing an HMI on a heat pump that is already paired
Possible to access level 3 by removing the batteries???
In the "UNIT CONFIGURATION" tab, select "Pairing". The screens below will appear:
Select "Maintenance" using the
button
then
CLIC
PAIRING
SYSTem pairing
B
ack
HeaT pump pairing
Maintenance
Select "Element reset" using the button then
maintenance
range TeST
B
ack
Element reset
Select "HtPump rst out sys." using the button
then
maintenance
HeaT pump reSeT
B
ack
H
Tpump
rst
ouT SYS.
The display opposite appears
MAINTENANCE
HTpump ouT SYS.
warning
reSeT?
S
eTTing: canceL