What to do if my CIGWELD Inverter weld has porosity due to dirty workpiece?
If you notice porosity in your weld due to a dirty workpiece while using your CIGWELD Inverter, clean contaminants off the workpiece before welding.
What to do if my CIGWELD Inverter has porosity due to MIG torch maintenance?
If you are experiencing porosity issues with your CIGWELD Inverter due to MIG torch maintenance, consider the following: * Ensure that the gas holes are not blocked and gas is exiting out of the torch nozzle. * Prevent spatter buildup inside the torch nozzle to avoid restricting gas flow. * Check that the MIG torch O-rings are not damaged.
What to do if CIGWELD Inverter weld has porosity due to shielding gas cylinder issues?
If your CIGWELD Inverter weld shows porosity and you suspect the shielding gas cylinder, ensure that the shielding gas cylinder is not empty and the flow meter is correctly adjusted to 15 litres per minute.
What to do if my CIGWELD Inverter has porosity due to gas leaks?
If you're experiencing porosity problems with your CIGWELD Inverter welds, check for gas leaks between the regulator/cylinder connection and in the gas hose leading to the power source.
How to fix porosity due to MIG torch nozzle distance with my CIGWELD Inverter?
To address porosity issues when using your CIGWELD Inverter, keep the distance between the MIG torch nozzle and the workpiece to a minimum.
General| Brand | CIGWELD |
|---|---|
| Model | 200i |
| Category | Welding System |
| Language | English |
To Next Page
