IMPORTANT SAFETY INSTRUCTIONS. Read and follow all instructions.
Ensure all owners / operators of this equipment have access to these
instructions. Save all instructions.
WARNING: Follow all aspects of local and National Electrical Code(s)
when installing the CircuPool Universal Series. Disconnect all
electrical power during installation & service.
WARNING: To reduce the risk of injury, do not permit children to
operate this device. Service should only be attempted by a qualified
professional.
WARNING: Heavy pool (and/or spa) usage and higher temperatures
may require higher chlorine output to maintain proper free
available chlorine residuals. The actual amount of chlorination
required by your pool can change, and varies according to factors
not limited to bather load, rain, temperature, dirt, debris, and
chemical balance.
WARNING: Safe operation of the electrolytic cell requires a
minimum water flow rate of 20 gpm. Never operate the unit when
the flow of water is restricted. Always turn unit off when operating
any plumbing control valves such as for backwashing, water
exhaust, or during operation of spa or water features if operation
restricts water flow to the cell. A build-up of flammable gases will
result in hazardous conditions.
WARNING: We strongly recommend against the use of isolation
valves. If full pump pressure is applied to an isolated component, it
may be prone to rupture. Turn off all pumps before changing valve
positions. Prevent water pressure spikes at Electrolytic Cell.
Before installation, ensure that materials and equipment used in
and around the pool are compatible with the use of chlorinated
water and salt. Avoid high chlorine and high salt levels (above the
recommended range); it is possible that certain materials and pool
(and/or spa) equipment may be susceptible to damage.
Ensure that the chlorinator operates only when the circulation
pump is operating. When installed with a pool equipment timer or
control system, the Control Module (wall unit) must be to the load
side of the timer clock or control relay.
To Next Page
Loading...
