Cirrus Design Section 4
SR22 Normal Procedures
P/N 13772-004 4-13P/N 13772-004 4-13
Before Takeoff
During cold weather operations, the engine should be properly
warmed up before takeoff. In most cases this is accomplished when
the oil temperature has reached at least 100°F (38°C). In warm or hot
weather, precautions should be taken to avoid overheating during
prolonged ground engine operation. Additionally, long periods of idling
may cause fouled spark plugs.
• WARNING •
Do not takeoff with frost, ice, snow, or other contamination on
the fuselage, wing, stabilizers, and control surfaces.
1. Doors ..............................................................................LATCHED
2. CAPS Handle ..................................................Verify Pin Removed
3. Seat Belts and Shoulder Harness.................................... SECURE
4. Air Conditioner .......................................................... AS DESIRED
• Caution •
Use of RECIRC mode prohibited in flight.
• Note •
If Air Conditioner is ON for takeoff roll, see Section 5, Take o f f
Distance for takeoff distance change. No takeoff distance
change is necessary if system remains OFF for takeoff roll.
5. Fuel Quantity ................................................................. CONFIRM
6. Fuel Selector......................................................... FULLEST TANK
7. Fuel Pump ......................................................................... BOOST
8. Mixture ................................................................... AS REQUIRED
9. Flaps ...............................................................SET 50% & CHECK
10. Transponder............................................................................. SET
11. Autopilot ............................................................................. CHECK
12. Navigation Radios/GPS ......................................... SET for Takeoff
13. Cabin Heat/Defrost ................................................ AS REQUIRED
14. Brakes................................................................................... HOLD
15. Power Lever ................................................................... 1700 RPM
(Continued on following page)
Original Issue
To Next Page
Loading...
