EasyManua.ls Logo

Cirrus SR22 - Lift Transducer Overheat Warning; Tank Control Failure Warning

Cirrus SR22
524 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
P/N 13772-150 13 of 50
Cirrus Design Section 9
SR22 Supplements
4. ICE PROTECT Mode Switch ................................................. HIGH
If warning annunciation extinguishes:
a. Anti-Ice System ....................................................... MONITOR
If warning annunciation does not extinguishes or intermittent:
a. PUMP BKUP Switch............................................................ON
b. Icing Conditions.................................................. AVOID / EXIT
Lift Transducer Overheat Warning
PFD Alerts Window: “AOA probe is overheated”
• Note •
Operation of Pitot Heat on hot days may annunciate the AOA
OVERHEAT Warning when flying at slow speeds. When air
temperatures are greater than 41°F (5°C), operation of Pitot
Heat is at discretion of the pilot. If overheat warning is
annunciated, Pitot Heat should remain OFF.
1. PITOT HEAT Switch.................................................................OFF
2. Icing Conditions .......................................................... AVOID/EXIT
Tank Control Failure Warning
PFD Alerts Window: “Tank valves cannot be controlled (closed) (TKS)”
Tank selection is inoperative and both left and right are open, typical
with GIA failure.
1. Icing Conditions ........................................................ AVOID / EXIT
AOA OVERHEAT
ANTI ICE CTL
Original Issue: 02-01-13

Table of Contents

Other manuals for Cirrus SR22

Related product manuals