Outdoor Access Points (MR6X, MR7X)
To reset a MR6X or MR7X outdoor access point to the factory defaults, press the button labeled 'Reset' below the Ethernet port of the AP for 10-15 seconds.
This will clear the static IP address settings and local configuration of the device. Please be aware that after resetting the unit, the device will need to download
its latest configuration from Dashboard. Please be patient as this could take up to 5 - 10 minutes.
To setup a static IP address on a Cisco Meraki AP, visit the knowledge base article for Static IP Assignment on a Cisco Meraki Access Point.
5
To Next Page
Loading...
