Cisco 1601 - Router - EN - Page 156

10/100BASE-T Ethernet Switch High-Speed WAN Interface Cards
Installing Inline Power Daughter Cards on Cisco 10/100BASE-T Ethernet Switch HWICs
4
OL-12850-01
Installing a Daughter Card on the HWIC-4ESW Card
To install an inline power daughter card on the HWIC-4ESW card, perform the following steps:
Step 1 Install the three standoffs (included with the daughter card) on the HWIC motherboard, as shown in
Figure 111, with the provided fastening screws. Tighten the screws firmly.
Figure 111 Installing an Inline Power Card on the Cisco 10/100BASE-T Ethernet Switch
HWIC-4ESW Card
Step 2
Plug the daughter card connector into the motherboard connector, making sure that the standoffs align
correctly underneath the mounting holes in the daughter card.
Step 3 Connect the daughter card to the standoffs with the provided fastening screws. Tighten the screws firmly.
1 Fastening screws: daughter card to
standoffs
4 Daughter card
2 Standoffs (3) 5 Daughter card connector
3 Fastening screws: standoffs to
motherboard
6 Motherboard connector
5
6
4
22
2
1
103113
3