Cisco 1941 User Manual

7
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Chapter Overview of the Hardware and Software
Getting Started
Getting Started
See the router-specific hardware installation guide to install the router in an appropriate location.
Connect the router with the appropriate cables. Supply power to the router and perform the initial
software configuration using Cisco Configuration Professional Express. After the initial configuration
is completed, perform the following steps:
Step 1 Follow instructions in the “Basic Router Configuration” section on page 13 to perform additional router
configurations.
Step 2 (Optional) If you are setting up the Cisco 1941W ISR, follow instructions in the “Configuring the
Wireless Device” section on page 247 to configure the embedded wireless device on the router.
Step 3 Follow instructions in the “Configuring Security Features” section on page 127 to configure security
features on the router.
Step 4 Follow instructions in the “Unified Communications on Cisco Integrated Services Routers” section on
page 169 to configure Voice features on the router.

Cisco 1941 Specifications

General

Product Type	Router
Product Series	1900
Model	1941
Connectivity Technology	Wired
Data Link Protocol	Ethernet, Fast Ethernet, Gigabit Ethernet
Flash Memory	256 MB
Power Supply	Internal power supply
Power	AC 120/230 V (50/60 Hz)
Operating System	Cisco IOS
Product Name	Cisco 1941
Form Factor	Rack-mountable
Network/Transport Protocol	IPSec, L2TP, PPPoE, PPPoA
Remote Management Protocol	SNMP, Telnet, SSH, HTTP, HTTPS
Features	Firewall protection, VPN support, VLAN support
Interfaces	2 x 10/100/1000Base-T Ethernet WAN, 2 x USB 2.0
Expansion Slots	2 x EHWIC 1 x ISM slot
Wireless LAN	No
RAM	512 MB (installed) / 768 MB (max)