EasyManuals Logo

Cisco 1941 User Manual

Cisco 1941
408 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
28
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Chapter Basic Router Configuration
Configuring Dynamic Routes
Example
The following configuration example shows the EIGRP routing protocol enabled in IP networks
192.145.1.0 and 10.10.12.115. The EIGRP autonomous system number is 109.
To see this configuration use the show running-config command, beginning in privileged EXEC mode.
Router# show running-config
...
!
router eigrp 109
network 192.145.1.0
network 10.10.12.115
!
...
Verifying Configuration
To verify that you have properly configured IP EIGRP, enter the show ip route command, and look for
EIGRP routes indicated by “D.” You should see verification output similar to the following:
Router# show ip route
Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default, U - per-user static route
o - ODR, P - periodic downloaded static route
Gateway of last resort is not set
10.0.0.0/24 is subnetted, 1 subnets
C 10.108.1.0 is directly connected, Loopback0
D 3.0.0.0/8 [90/409600] via 2.2.2.1, 00:00:02, Ethernet0/0

Table of Contents

Other manuals for Cisco 1941

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 1941 and is the answer not in the manual?

Cisco 1941 Specifications

General IconGeneral
Product TypeRouter
Product Series1900
Model1941
Connectivity TechnologyWired
Data Link ProtocolEthernet, Fast Ethernet, Gigabit Ethernet
Flash Memory256 MB
Power SupplyInternal power supply
PowerAC 120/230 V (50/60 Hz)
Operating SystemCisco IOS
Product NameCisco 1941
Form FactorRack-mountable
Network/Transport ProtocolIPSec, L2TP, PPPoE, PPPoA
Remote Management ProtocolSNMP, Telnet, SSH, HTTP, HTTPS
FeaturesFirewall protection, VPN support, VLAN support
Interfaces2 x 10/100/1000Base-T Ethernet WAN, 2 x USB 2.0
Expansion Slots2 x EHWIC 1 x ISM slot
Wireless LANNo
RAM512 MB (installed) / 768 MB (max)

Related product manuals