vertical wall stud. (See Figure 3-9.) This position will prevent the chassis from pulling away from
the wall when cables are attached.
For the best ventilation of the chassis, mount the chassis with the power supply and fan at the top.
Make sure there is clearance between the router and the wall.
ā
Figure 3-9: Wall-Mounting the Chassis
Connecting the DC Power Supply
The multiport serial router has an optional direct current (DC) power supply. This section describes the
DC power supply specifications and wiring.
DC Power Specifications
The DC power supply is intended for use in DC operating environments. Table 3-1 lists the power supply
specifications.
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_fix/cis2500/2520/2520_23/c2520ins.htm (6 of 14) [10/27/2000 3:07:47 PM]
To Next Page
Loading...
