Is this interface in use? [no]: yes
Configure IP unnumbered on this interface? [no]: yes
IP address for this interface: 172.16.74.2
Number of bits in subnet field [8]:
Class B network is 172.16.0.0, 8 subnet bits; mask is 255.255.255.0
Configure AppleTalk on this interface? [no]: yes
Extended AppleTalk network? [yes]:
AppleTalk starting cable range [2]: 4
AppleTalk ending cable range [3]: 4
AppleTalk zone name [myzone]: ZZ Serial
AppleTalk additional zone name:
Configure IPX on this interface? [no]: yes
IPX network number [2]: B002
Step 4 Continue to configure the remaining serial port(s) using similar parameters.
The multiport serial router is now configured properly and is ready to use. Enter the setup command to
modify the parameters after the initial configuration. Enter the configure command to perform more complex
configurations. For additional information, refer to the publication Cisco IOS command reference publication.
Step 5 Check the router settings by entering the show running-config command at the enable prompt:
Router# show running-config
.
.
.
configuration register is 0x2102
Step 6 Store the configuration, or changes to the startup configuration, by entering the copy running-config
startup-config command at the enable prompt:
Router# copy running-config startup-config
Entering this command saves the configuration settings that the setup process created in the router. If you fail
to do this, the configuration is lost the next time the router is loaded.
Setting Asynchronous Serial Ports
The ports you plan to use as low-speed asynchronous serial ports must be reconfigured after the initial setup
because the ports are initially configured as low-speed synchronous serial ports.
Take the following steps to configure a synchronous serial port to be an asynchronous serial port:
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_fix/cis2500/2520/2520_23/c2520cfg.htm (11 of 16) [10/27/2000 3:07:51 PM]
To Next Page
Loading...
Need help?
General
