Step 5 Enter the enable secret password, the enable password, and the virtual terminal password:
The enable secret is a one-way cryptographic secret used
instead of the enable password when it exists.
Enter enable secret : shovel
The enable password is used when there is no enable secret
and when using older software and some boot images.
Enter enable password : trowel
Enter virtual terminal password: pail
Enter yes or no to accept or refuse SNMP management:
Configure SNMP Network Management? [yes]:no
The Simple Network Management Protocol (SNMP) is the most widely supported open standard for network
management. It provides a means to access and set the configuration and run-time parameters of a multiport
serial router. SNMP defines a set of functions used to monitor and control network elements.
Step 6 Determine if you are using DECnet on the router. If you are configuring for DECnet, enter the
appropriate values for your area number, node number, and area routing:
Configure DECnet? [no]:
Step 7 In most cases, you use IP routing. For IP routing, you must also select one of two interior routing
protocols: Interior Gateway Routing Protocol (IGRP) or Routing Information Protocol (RIP).
Enter yes or press Return (the default) to configure IP, and then select an interior routing protocol for IP:
Configure IP? [yes]:
Configure IGRP routing? [yes]:
Your IGRP autonomous system number [1]: 15
Configure CLNS? [no]:
Configure bridging? [no]:
Configure IPX? [no]: yes
Configure XNS? [no]:
Configure Apollo? [no]:
Step 8 Enter the ISDN BRI switch type for the router. The ISDN switch type appropriate for the router
depends on the ISDN provider's equipment. Table 4-1 lists the ISDN switch types.
Enter ISDN BRI Switch Type [none]: basic-5ess
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_fix/cis2500/2520/2520_23/c2520cfg.htm (7 of 16) [10/27/2000 3:07:51 PM]
To Next Page
Loading...
