Cisco 2921 User Manual

61
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Configuring Ethernet Virtual Connection Bridge
Domain
Ethernet virtual connection (EVC) infrastructure is a Layer 2 platform-independent bridging
architecture that supports Ethernet services. This chapter provides procedures for configuring EVC
Bridge Domain (BD) and the features it supports on the Cisco Integrated Services Routers (ISR) G2.
• Configuring EVCs on Cisco ISR G2 Router, page 61
• Ethernet Data Plane Loopback, page 64
• Connectivity Fault Management (CFM) over EVC BD, page 68
• Support for Y.1731 Performance Monitoring for EVC BD, page 87
• Support for Switch Virtual Interfaces (SVI) on ISR G2 Metro Ethernet BD, page 90
• EVC Quality of Service (QoS), page 92
Configuring EVCs on Cisco ISR G2 Router
Configuring an EFP and a BD on the Cisco ISR G2 Router
Configuring a service instance on a Layer 2 port creates an EFP on which you can configure EVC
features.
Note • You cannot use the same VLAN ID for encapsulating on a Layer 3 sub-interface and an EFP (service
instance) on a WAN interface.
• If there is a sub-interface and service-instance both configured on a WAN interface for untagged
traffic, then the traffic will always go to the main interface and the service-instance with untagged
traffic will not work.
Perform this task to configure an EFP.
SUMMARY STEPS
Step 1 enable
Step 2 configure terminal

Cisco 2921 Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.1Q, IEEE 802.1ag, IEEE 802.3, IEEE 802.3ab, IEEE 802.3af, IEEE 802.3ah, IEEE 802.3u
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
Product color	Black
Rack capacity	2U
USB version	2.0
RS-232 ports	1
USB ports quantity	2
Ethernet LAN (RJ-45) ports	3
DHCP client	-
Routing protocols	BGP, EIGRP, OSPF
Supported protocols	IPv4, IPv6, IS-IS, IGMPv3, PIM SM, SSM, DVMRP, IPSec, GRE, BVD, MPLS, L2TPv3, PPP, MLPPP, MLFR, HDLC, RS-232, RS-449, X.21, V.35, EIA-530, PPPoE, ATM
Firewall security	Cisco IOS
Operating altitude	0 - 3000 m
Non-operating altitude	0 - 4570 m
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	10 - 85 %
AC input voltage	100 - 240 V
Power source type	AC
AC input frequency	47 - 63 Hz
Safety	UL 60950-1, CAN/CSA C22.2 No. 60950-1, EN 60950-1, AS/NZS 60950-1, IEC 60950-1
Electromagnetic compatibility	47 CFR, ICES-003, EN55022, CISPR22, AS/NZS 3548, VCCI V-3, EN 300-386, EN 61000, EN 55024, CISPR 24EN50082-1

Weight and Dimensions

Depth	469.9 mm
Width	438.2 mm
Height	88.9 mm
Weight	13200 g