Cisco 3504 User Manual

ActionWizard Setting
If desired, enter the name of the mobility group/RF group to which you want the
controller to belong.
Although the name that you enter here is assigned to both the mobility group and
the RF group, these groups are not identical. Both groups define clusters of
controllers, but they have different purposes. All of the controllers in an RF group
are usually also in the same mobility group and vice versa. However, a mobility
group facilitates scalable, system-wide mobility and controller redundancy while an
RF group facilitates scalable, system-wide dynamic RF management.
Mobility/RF Group
Name
Enter the network name, or service set identifier (SSID). This is the default SSID
that the access points use when they join a controller.
Network Name
(SSID)
Enter yes to configure DHCP Bridging Mode. Values are yes or no. The following
message appears:
Warning! The default WLAN security policy requires a RADIUS server.
Please see documentation for more details.
Configure DHCP
Bridging Mode
Enter YES to allow clients to assign their own IP address or no to make clients
request an IP address from a DHCP server. Values are YES or no. The default setting
is YES.
Allow Static IP
Addresses
If you select YES, you are prompted to enter the following:
•
RADIUS Server IP address
•
RADIUS server port (default port is 1812)
•
RADIUS Server secret
If you select no, the following message appears:
Warning! The default WLAN security policy requires a RADIUS server.
Please see documentation for more details.
Configure a RADIUS
Server Now?
Enter the two letter country code. The default country code is the United States (US).
Enter ‘help’ to see a list of countries.
Enter Country Code
List
Choose YES to enable or no to disable the 802.11b radio network. The default is
YES.
Enable 802.11b
Network
Choose YES to enable or no to disable the 802.11a radio network. The default is
YES.
Enable 802.11a
Network
Choose YES to enableEnable 802.11g
Network
Choose YES to enable or no to disable radio resource management. The default is
YES.
Enable Auto-RF
Enter YES to configure an NTP server. The values are YES or no. The default value
is YES.
Configure a NTP
server now?
Cisco 3504 Wireless Controller Installation Guide
31
Installing the Cisco 3504 Wireless Controller
Using the Startup Wizard

Cisco 3504 Specifications

General

Networking standards	IEEE 802.11a, IEEE 802.11ac, IEEE 802.11b, IEEE 802.11d, IEEE 802.11e, IEEE 802.11g, IEEE 802.11h, IEEE 802.11k, IEEE 802.11n, IEEE 802.11r, IEEE 802.11u, IEEE 802.11w, IEEE 802.1AX, IEEE 802.1Q, IEEE 802.3, IEEE 802.3u
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet LAN (RJ-45) ports	4
LED indicators	Network, Status
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	5 - 95 %
Security algorithms	802.1x RADIUS, HTTPS, SNMP, SNMPv3, SSH, SSL/TLS, WEP, WPA, WPA2
Web-based management	Yes

Weight and Dimensions

Weight	2000 g
Dimensions (WxDxH)	214.3 x 215.9 x 43.94 mm