4-50
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line
Configuration Sequence
Step 7 To set the DSCP value used as the interface default DSCP value to tag the backhaul packet, use the
following command:
Router(config-if)# umts-iub set dscp
value
Where value is a number chosen to represent that packet of traffic.
For example, the following command specifies the number 16 for the packet of traffic for the umts-iub
interface:
Router(config-if)# umts-iub set dscp 16
Step 8 Perform Steps 5 through 7 to set another PVC 2/2 with a umts-iub interface DSCP of 8.
Step 9 To overwrite the previous PVC 2/1 with a umts-iub interface DSCP of 16, use the following command:
Router(config-if)# umts-iub set dscp
value
Where value is a number chosen to represent that packet of traffic.
For example, the following command overwrites the number 16 for the packet of traffic for the umts-iub
interface:
Router(config-if)# umts-iub set dscp 16
Step 10 To configure the local parameters required to establish an IP/UDP backhaul connection, enter the
following command including the IP address and port you want to establish the IP/UDP backhaul
connection from.
Router(config-if)# umts-iub local
ip-address port
For example, the following command configures the umts-iub local interface with an IP address and port
of 20.20.20.21 6666:
Router(config-if)# umts-iub local 20.20.20.21 6666
Step 11 To configure the remote parameters required to establish an IP/UDP backhaul connection, enter the
following command including the IP address and port you want to establish the IP/UDP backhaul
connection from.
Router(config-if)# umts-iub remote
ip-address port
For example, the following command configures the umts-iub remote interface with an IP address and
port of 20.20.20.20 6666:
Router(config-if)# umts-iub remote 20.20.20.20 6666
Step 12 Perform Steps 1 to 7 for ATM0/0/1 with a UMTS DSCP of 8.
Step 13 To overwrite the previous PVC 2/1 with a umts-iub interface DSCP of 16, use the following command:
Router(config-if)# umts-iub set dscp
value
Where value is a number chosen to represent that packet of traffic.
For example, the following command overwrites the number 16 for the packet of traffic for the umts-iub
interface:
Router(config-if)# umts-iub set dscp 16
Step 14 To configure the local parameters required to establish an IP/UDP backhaul connection, enter the
following command including the IP address and port you want to establish the IP/UDP backhaul
connection from.
Router(config-if)# umts-iub local
ip-address port
To Next Page
Loading...
