Cisco 3825 - Mode Y-Cable

A-119
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
standalone
standalone
To specify that the Cisco 3825 router is being used in a standalone configuration (which impacts the
relays on the VWIC/HWIC), use the standalone command in y-cable configuration mode. To use the
router in a redundant configuration, use the no form of this command.
[no] standalone
Syntax Description This command has no arguments or keywords.
Defaults By default, the Cisco 3825 router is configured to be used in a redundant configuration (no standalone)
and the relays are open.
Command Modes Y-cable configuration
Command History
Usage Guidelines Issuing the standalone command closes the relays on the VWICs/HWICs installed in the Cisco 3825
router.
Examples The following example closes the relays so that the router can be used as a standalone device.
Router# standalone
Related Commands
Release Modification
12.2(8)MC2 This command was introduced.
12.2(15)MC1 This command was incorporated.
12.3(11)T This command was incorporated.
12.4(2)MR This command was incorporated.
Command Description
mode y-cable Invokes y-cable mode.
standby use-interface Specifies the interfaces to be used for health and revertive interfaces.