CHAPTER
4-1
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
4
Configuring the Cisco 3825 Mobile Wireless
Edge Router in a RAN-O Solution with the
Command-Line Interface
This chapter describes how to use the Cisco IOS software CLI to configure the Cisco 3825 Mobile
Wireless Edge Router in a Radio Access Network-Optimization (RAN-O) solution and includes the
following sections:
• Before You Begin, page 4-2
• Verifying the Version of Cisco IOS Software, page 4-2
• Clocking Requirements for Cisco 3825 Router, page 4-2
• Show Controller Command, page 4-5
• Configuration Sequence, page 4-6
• Configuring the Hostname and Password, page 4-6
• Configuring Gigabit Ethernet Interfaces, page 4-8
• Configuring the Backhaul Links, page 4-9
• Configuring GSM-Abis Links, page 4-20
• Configuring UMTS Links, page 4-24
• Configuring Redundancy, page 4-28
• Configuring for SNMP Support, page 4-33
• Configuring Inverse Multiplexing over ATM (IMA), page 4-37
• Configuring PVC Routing (HSDPA Offload), page 4-41
• Configuring UMTS QoS, page 4-46
• Configuring UMTS Congestion Management Control, page 4-55
• Configuring Satellite Support, page 4-58
• Configuring Graceful Degradation, page 4-59
• Saving Configuration Changes, page 4-61
• Example Configurations, page 4-61
• Monitoring and Managing the Cisco 3825 Router, page 4-69
• Where to Go Next, page 4-73
To Next Page
Loading...
