Cisco 3825 - Sample Rate

A-69
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
sample-rate
sample-rate
To specify in milliseconds the rate hardware samples the data on the attached circuit, use the
sample-rate command in the circuit emulation (CEM) circuit configuration mode.
sample-rate [sample-rate]
Syntax Description
Command Modes CEM circuit configuration
Command History
Examples The following example illustrates the use of the sample-rate command:
Router# config t
Router(config)# interface cem 0/0/0
Router(config-if)# no ip address
Router(config-if)# cem 0
Router(config-if-cem)# sample-rate 2
Router(config-if-cem)# xconnect 10.10.10.10 200 encapsulation mpls
Router(config-if-cem-xconn)# exit
Router(config-if-cem)# exit
Router(config-if)# exit
Router(config)# exit
Related Commands
sample rate Sample rate translates into the payload-size sent over the circuit. The default
is 1 ms.
• 32-timeslots at 1ms = 256-bytes (32-timeslots * 8-bytes/timeslot/ms)
• 24-timeslots at 2ms = 384-bytes (24-timeslots * 16-bytes/timeslot/ms)
Release Modification
12.4(12)MR2 This command was introduced.
Command Description
cem Apply CEM class.
cem class Applies the CEM interface parameters defined in the given
<cem-class-name> to the circuit.
class cem Configure’s CEM interface parameters in a class that’s applied to
CEM interfaces together in the global configuration mode.