A-125
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
umts-iub congestion priority
umts-iub congestion priority
To configure the congestion control priority for UMTS, use the umts-iub congestion priority PVC
configuration command.
umts-iub congestion priority [protected] [2-9]
Syntax Description
Defaults The default setting is 9.
Command Modes PVC configuration
Command History
Examples The following example shows how to configure the UMTS congestion priority:
Router(config-if) pvc 2/1 qsaal
Router(config-if-atm-vc) umts-iub congestion priority protected
Related Commands
protected The highest priority traffic which will never be throttled during congestion.
2-9 The congestion priority with 2 being the highest and 9 being the lowest
priority. Lower priority traffic are throttled before higher priority traffic.
Release Modification
12.4(4)MR1 This command was introduced.
Command Description
umts-iub congestion-control Enables the congestion control under the UMTS shorthaul interface.
To Next Page
Loading...
