Cisco 3825 - Page 139

A-7
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
backup delay
The following example shows an MPLS xconnect with one redundant peer. The switchover does not
begin unless the Layer 2 Tunnel Protocol (L2TP) PW has been down for three seconds. After a
switchover to the secondary VC occurs, there is no fallback to the primary until the primary VC has been
reestablished and is up for ten seconds.
Router# config t
Router(config)# pseudowire-class mpls
Router(config-pw-class)# encapsulation mpls
Router(config-pw-class)# exit
Router(config)# interface atm1/0/0
Router(config-if)# xconnect 10.0.0.1 50 pw-class mpls
Router(config-if-xconn)# backup peer 10.0.0.2 50
Router(config-if-xconn)# backup delay 3 10
Router(config-if-xconn)# exit
Router(config-if)# exit
Router(config)# exit
Related Commands Command Description
backup peer Configures a redundant peer for a PW VC.