A-65
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
pseudowire-class
pseudowire-class
To specify the name of a Layer 2 pseudowire-class and enter pseudowire-class configuration mode, use
the pseudowire-class command in the global configuration mode.
pseudowire-class [pw-class-name]
Syntax Description
Defaults No pseudowire-class is defined.
Command Modes Global configuration
Command History
Usage Guidelines The pseudowire-class command configures a pseudowire-class template that consists of configuration
settings used by all attachment circuits bound to the class. A pseudowire-class includes the following
configuration settings:
• Data encapsulation type
• Control protocol
• Sequencing
• IP address of the local Layer 2 interface
• Type of service (ToS) value in IP headers
After entering the pseudowire-class command, the router switches to pseudowire-class configuration
mode where PW settings can be configured.
Examples The following example shows how to enter pseudowire-class configuration mode to configure a PW
configuration template named “ether-pw”:
Router# config t
Router(config)# pseudowire-class l2tp
Router(config-pw-class)# encapsulation l2tpv3
Router(config-pw-class)# exit
Router(config)# exit
pw-class-name (Required) The name of a Layer 2 pseudowire-class.
Release Modification
12.0(23)S This command was introduced.
12.3(2)T This command was integrated into Cisco IOS Release 12.3(2)T.
12.4(12)MR2 This command was integrated into Cisco IOS Release 12.4(12)MR2.
To Next Page
Loading...
