Cisco 3825 - Page 199

A-67
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
pw-pvc
pw-pvc
To configure permanent virtual circuit (PVC) mapping or rewrite the PW configured for a PVC, use the
pw-pvc command. This command specifies the PW-side vpi/vci value to be used inside PW packet
payload in sending and receiving PW packets for a specified PVC.
pw-pvc [pw-vpi]/[pw-vci]
Syntax Description
Defaults By default, PW-side vpi/vci value is the same as the attachment circuit-side vpi/vci value.
Command Modes l2transport VC mode
Command History
Examples The following example illustrates the use of the pw-pvc command.
Router# config t
Router(config-if)# pvc 0/40 l2transport
Router(config-if-atm-l2trans-pvc)# encapsulation aal0
Router(config-if-atm-l2trans-pvc)# pw-pvc 1/40
Router(config-if-atm-l2trans-pvc)# xconnect 1.1.1.1 40 encapsulation mpls
Router(config-if-atm-l2trans-pvc-xconn)# exit
Router(config-if-atm-l2trans-pvc)# exit
Router(config-if)# exit
Router(config)# exit
Related Commands
pw-vpi Pseudowire-side vpi value
pw-vci Pseudowire-side vci value
Release Modification
12.4(2)MR2 This command was introduced.
Command Description
xconnect The xconnect command is used to bind an attachment circuit to a PW
in one of the supported configuration modes.