Cisco 3825 - Page 236

A-104
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
show umts-iub errors
show umts-iub errors
To display the error statistics of the UMTS Iub interface, use the show umts-iub errors command in
privileged EXEC mode.
show umts-iub errors
Syntax Description This command has no arguments or keywords.
Command Modes Privileged EXEC
Command History
Examples The following are examples of the output generated by this command.
Example 1:
Receiving traffic from shorthaul when the peering connection is not connected with the remote router
yet.
Router# show umts errors atm 0/0/1
UMTS-Iub(ATM0/0/1): backhaul_peer_not_ready ========= 5
5 is the number of packets received from shorthaul.
Example 2
The peering connection is up and shorthaul is receiving traffic from a pvc that's NOT configured on the
remote peering router’s shorthaul.
Router# show umts errors atm 0/0/1
UMTS-Iub(ATM0/0/1): no_remote_pvc =============== 5
5 is also the number of packets.
Example 3
Error statistics that the code keeps track of if the number is not zero.
Router# show umts errors
UMTS-Iub(ATM1/1/1): backhaul_peer_not_ready ===== 6
UMTS-Iub(ATM1/1/1): no_remote_pvc =============== 6
UMTS-Iub(ATM1/1/1): backhaul_invalid_pak ======== 1
UMTS-Iub(ATM1/1/1): decompression_failures ====== 1
UMTS-Iub(ATM1/1/1): no_shorthaul_pak_available == 1
UMTS-Iub(ATM1/1/1): compression_failures ======== 1
UMTS-Iub(ATM1/1/1): no_backhaul_pak_available === 1
UMTS-Iub(ATM1/1/1): no_backhaul_interface ======= 1
UMTS-Iub(ATM1/1/1): backhaul_interface_down ===== 1
Release Modification
12.4(2)MR This command was introduced.