EasyManua.ls Logo

Cisco 3825 - Page 239

Cisco 3825
358 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
A-107
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
show umts-iub peering
show umts-iub peering
To display the peering status, statistics, and history of the UMTS Iub interface, use the show umts-iub
peering command in privileged EXEC mode.
show umts-iub peering [details]
Syntax Description
Command Modes Privileged EXEC
Command History
Examples The following are examples of the output generated by this command.
Example 1
Router# show umts peering atm 0/0/1
UMTS-Iub(ATM0/0/1): Peering Information
UMTS-Iub(ATM0/0/1): Local (40.40.40.40:6666) States:
UMTS-Iub(ATM0/0/1): Connect State: OPEN
UMTS-Iub(ATM0/0/1): Redundancy State: ACTIVE
UMTS-Iub(ATM0/0/1): Alarm State: RX(NO ALARM) TX(NO ALARM)
UMTS-Iub(ATM0/0/1):Version: 1
UMTS-Iub(ATM0/0/1): Remote (40.40.40.41:6666) States:
UMTS-Iub(ATM0/0/1): Alarm State: RX(NO ALARM) TX(NO ALARM)
UMTS-Iub(ATM0/0/1): Version: 1
Example 2
Router# show umts peering detail atm 0/0/1
UMTS-Iub(ATM0/0/1): Peering Information (Version 1)
05/15/02 02:35:50 AM: BACKHAUL UP INIT --> CLOSED
05/15/02 02:35:50 AM: OPEN CLOSED --> CON_SENT
05/15/02 02:35:50 AM: CLOSE CON_SENT --> CLOSING
05/15/02 02:35:50 AM: OPEN CLOSING --> STOPPING
05/15/02 02:35:59 AM: TIMEOUT- STOPPING --> STOPPED
05/15/02 02:36:28 AM: OPEN STOPPED --> CON_SENT
05/15/02 02:36:28 AM: RCR+ CON_SENT --> ACK_SENT
05/15/02 02:36:28 AM: RCA ACK_SENT --> OPEN
03/01/02 12:00:37 AM: Local RX(NOT AVAILABLE) TX(NOT AVAILABLE), Remote RX(NOT
AVAILABLE) TX(NOT AVAILABLE)
05/15/02 02:35:52 AM: Local RX(NO ALARM ) TX(NO ALARM ), Remote RX(NOT
AVAILABLE) TX(NOT AVAILABLE)
05/15/02 02:36:28 AM: Local RX(NO ALARM ) TX(NO ALARM ), Remote RX(NO ALARM
) TX(NO ALARM )
details Provides detail information about peering.
Release Modification
12.4(2)MR This command was introduced.
12.4(4)MR This command added IMA in the output, how traffic for a PVC is off loaded
to an alternate backhaul, and how alarms are carried over primary backhaul.

Table of Contents

Related product manuals