Cisco 3825 - Page 94

4-36
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line
Configuration Sequence
• version—(Optional) Version of the SNMP used to send the traps. Version 3 is the most secure
model, as it allows packet encryption with the priv keyword. If you use the version keyword, one of
the following must be specified:
– 1—SNMPv1. This option is not available with informs.
– 2c—SNMPv2C.
– 3—SNMPv3. The following three optional keywords can follow the version 3 keyword:
–auth (Optional). Enables Message Digest 5 (MD5) and Secure Hash Algorithm (SHA) packet
authentication
–noauth (Default). The noAuthNoPriv security level. This is the default if the [auth | noauth |
priv] keyword choice is not specified.
–priv (Optional). Enables Data Encryption Standard (DES) packet encryption (also called
“privacy”).
• community-string—Password-like community string sent with the notification operation. Though
you can set this string using the snmp-server host command by itself, we recommend you define
this string using the snmp-server community command before using the snmp-server host
command.
• udp-port port—UDP port of the host to use. The default is 162.
• notification-type—(Optional) Type of notification to be sent to the host. If no type is specified, all
notifications are sent. The notification type can be one or more of the following keywords:
– aaa_server—Enable SNMP AAA Server traps.
– atm—Enable SNMP atm Server traps.
– ccme—Enable SNMP ccme traps.
– cnpd—Enable NBAR Protocol Discovery traps.
– config—Enable SNMP config traps.
– config-copy—Enable SNMP config-copy traps.
– cpu—Allow cpu related traps.
– dial—Enable SNMP dial control traps.
– dnis—Enable SNMP DNIS traps.
– ds0-busyout—Enable ds0-busyout traps.
– ds1—Enable SNMP DS1 traps.
– ds1-loopback—Enable ds1-loopback traps.
– ds3—Enable SNMP DS3 traps.
– dsp—Enable SNMP dsp traps.
– eigrp—Enable SNMP EIGRP traps.
– entity—Enable SNMP entity traps.
– envmon—Enable SNMP environmental monitor traps.
– flash—Enable SNMP FLASH notifications.
– frame-relay—Enable SNMP frame-relay traps.
– hsrp—Enable SNMP HSRP traps.
– icsudsu—Enable SNMP ICSUDSU traps.