Description and Default ValueParameter Name
Maximum delay (in seconds) the phone waits before performing a
resynchronization.
The device does not resync while one of its phone lines is active. Because a
resync can take several seconds, it is desirable to wait until the device has been
idle for an extended period before resynchronizing. This allows a user to make
calls in succession without interruption.
The device has a timer that begins counting down when all of its lines become
idle. This parameter is the initial value of the counter. Resync events are delayed
until this counter decrements to zero.
The default value is 14,400 seconds.
Forced Resync Delay
Enables a resync to be triggered via a SIP NOTIFY message.
The default value is Yes.
Resync From SIP
Enables or disables the resync operation after any upgrade occurs. If Yes is
selected, sync is triggered.
The default value is Yes.
Resync After Upgrade
Attempt
Configurable resync trigger conditions. A resync is triggered when the logic
equation in these parameters evaluates to TRUE.
The default value is (empty).
Resync Trigger 1, Resync
Trigger 2
A resync is considered unsuccessful if a requested profile is not received from
the server. This can be overridden by this parameter. When it is set to no, the
device accepts a file-not-found response from the server as a successful
resync.
The default value is Yes.
Resync Fails On FNF
Remote configuration profile rules evaluated in sequence. Each resync operation
can retrieve multiple files, potentially managed by different servers.
The default value is /$PSN.xml.
Profile Rule
Profile Rule B
Profile Rule C
Profile Rule D
DHCP options, delimited by commas, used to retrieve firmware and profiles.
The default value is 66,160,159,150,60,43,125.
DHCP Option To Use
This parameter contains the message that is sent to the syslog server at the start
of a resync attempt.
The default value is $PN $MAC –Requesting %
$SCHEME://$SERVIP:$PORT$PATH.
Log Request Msg
Cisco IP Phone 6800 Series Multiplatform Phones Provisioning Guide
65
Provisioning Parameters
Configuration Profile Parameters
To Next Page
Loading...
Need help?
General
